You can download the Bento software on github releases :
https://github.com/benkuper/BenTo/releases
<aside> 💡 If you’re on Mac and you don’t know whether you have Silicon or Intel, check this page here : Mac computers with Apple silicon - Apple Support
</aside>
If you just received Creators Clubs, or have new hardware and want to use them, there are few steps to achieve before you get to play !
Your props are likely having the factory program in them. In order to use them, you need to upload the firmware on them
The Firmware Uploader Panel will show you all the steps to upload the firmware on your prop, and set up the Wifi informations so you can then connect through Wifi to your props.
If you don’t see the Panel below, you can find it by click on the top menu View > Firmware Uploader
No Device detected, you will need to connect the prop or to install the driver if your prop is already connected
If you don’t see the props detected when plugging them, it’s probable that it’s not detected by the system because you don’t have the driver installed.
First you can download them here :
CP210x USB to UART Bridge VCP Drivers - Silicon Labs
Direct Links:
🪟 Windows : https://www.silabs.com/documents/public/software/CP210x_Universal_Windows_Driver.zip
🍎 Mac :
https://www.silabs.com/documents/public/software/Mac_OSX_VCP_Driver.zip
<aside> 💡 If you don’t know whether you have Silicon or Intel, check this page here : Mac computers with Apple silicon - Apple Support
</aside>
For Windows or Mac, you can download the installer shown with the red arrow
First you need to extract the downloaded zip file.
Then you need to locate the file silabser.inf and then right-click > Install
<aside> đź’ˇ You will need Administrator rights to be able to install the driver !
</aside>
You should after that you should be able to see the device in the Firmware Upload Panel
.png)
